







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Glenvar Heights, FL
Asphalt driveways & resurfacing in Glenvar Heights typically run $3,500 – $9,000 for a new asphalt drive and $250 – $700 for sealing, with most residential jobs finished in two to four days depending on square footage, base condition, and how much old surface has to come out. The bigger issue on acreage lots is heavy loads: if you park a boat trailer, a work truck, or a fifth-wheel on that drive, the base and the lift thickness matter more than the color of the aggregate. Call (888) 418-7102 to set up a free on-site estimate and we’ll measure the actual slab, not guess from a photo.
How we build an asphalt drive in Glenvar Heights, from demo to first drive-on

Asphalt is a schedule job, not a one-day patch. Here’s the honest sequence, with what you’ll be deciding along the way.
Stage 1: Site visit and measuring (day 0, about an hour). We walk the drive, probe the existing base, check where water runs off, and measure the actual footprint including any turn-around or apron. You decide the parking layout and whether the apron at US-1 side of the property gets a wider throat. The written quote comes with line items for demo, base, asphalt, and edges.
Stage 2: Demo and haul-off (day 1, four to eight hours). The old surface comes out. On 1950s – 1970s properties in the 33143 pocket, we frequently find a thin 2-inch layer poured over sand with no compacted base at all, which is why it cracked. You decide whether we replace that base or just re-grade it. We don’t guess; we show you the exposed subgrade.
Stage 3: Grading and base prep (day 2, one full day). Limerock base goes down in lifts and gets compacted with a plate and roller. Drainage falls toward the swale or a French drain. This is the single biggest determinant of how long the new asphalt lasts. It’s also the part most cheap quotes skip. You sign off on finished grade before we leave the site.
Stage 4: Asphalt paving (day 3, three to five hours). Hot-mix asphalt arrives and gets laid at 2 inches compacted for standard drives, 3 inches where we know trucks or trailers will sit. Edges get a clean, compactor-tamped shoulder. You pick the mix: standard or the tougher, coarser Grade S for heavy use.
Stage 5: Cure and seal window (7 – 90 days). You stay off it fully for 48 – 72 hours. Sealing happens on a separate visit after the asphalt cures, usually 60 – 90 days out in South Florida’s climate. We schedule that in writing so it doesn’t get forgotten.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
Most homeowners get stuck on two decisions: how thick the asphalt goes down and whether to seal right away. Here’s what actually moves the result.
- 2-inch vs. 3-inch compacted lift. Two inches is fine for a sedan and a light trailer. Three is the right call if a dually, a work van, or a 30-foot RV sits on it regularly. The cost difference for a standard Glenvar Heights drive lands a few hundred dollars at the low end to about a thousand at the high end of the $3,500 – $9,000 range.
- Standard mix vs. Grade S (heavy-traffic) mix. Grade S uses coarser aggregate and holds up better under parked weight and turning loads. It’s meaningfully more crack-resistant on a hot South Florida drive, and it’s what we recommend for anyone storing a boat or trailer on the pad.
- Limerock base thickness (4 inches vs. 6 – 8 inches). Thins are the most common reason a resurfaced drive fails in five years. Thicker base costs more upfront and adds a decade or more of life.
- Seal coat: now or after cure. Sealing too soon traps oils and can soften the surface. Wait 60 – 90 days, then seal every 2 – 3 years with a quality asphalt emulsion sealer. It’s a $250 – $700 line every couple of years that keeps a $6,000 drive from turning into a $12,000 replacement.
- Edges and apron. Concrete apron vs. asphalt to the road edge, and a defined shoulder vs. open grade. On acreage lots we usually shape a shoulder and stabilize it, so gravel and grass don’t creep onto the pavement.
What Asphalt Driveways & Resurfacing costs in Glenvar Heights, FL

For Glenvar Heights, asphalt driveway paving runs $3,500 – $9,000, and full driveway replacement (demo + new base + new asphalt) runs $5,000 – $14,000. Sealing and resurfacing sit at $250 – $700 per visit. If the drive is part of a full Driveway & Pavers in Glenvar Heights scope that also touches the walkway or apron, the numbers get laid out line-by-line so you can see what each piece costs.
Here are the variables that push a job to the low vs. high end:
- Square footage. A single-car drive is 250 – 300 sq ft. A long drive on an acreage lot can hit 800 – 1,200 sq ft. The footage is the biggest single multiplier.
- Existing condition. A sound surface can take a straight overlay. A cracked, settling, or thin-base drive needs full demo and rebuild, which moves the job toward $14,000.
- Base thickness and compaction. More limerock and more compaction time cost more but are what keep the drive flat for 15 – 20 years.
- Mix grade. Standard vs. Grade S is a few hundred dollars on a typical drive and is worth every dollar if anything heavy will park on it.
- Drainage and apron work. Adding a French drain, re-grading toward a swale, or cutting a wider apron adds to the job.
Our written estimate includes demo, haul-off, base, compaction, asphalt, edge finishing, and cleanup. What it typically doesn’t include: a permit (rarely needed for a residential drive but sometimes for anything that crosses a right-of-way or drainage easement), the future seal coat if it’s scheduled separately, and any landscaping repair off the pavement line.
See the difference
Before
After
Before
After
Before
AfterWhat Glenvar Heights’ housing stock and geography do to this job
Glenvar Heights is a small, largely built-out unincorporated pocket of Kendall, hemmed in by US-1 and the Palmetto Expressway. Almost nothing here is a new subdivision lot; nearly every paving job is a re-pave, an addition-adjacent drive, or a replacement on a lot the original builder paved in the 1960s. That 33143 housing stock – concrete-block ranch homes on generous, often fenced lots – pushes two things specific to this neighborhood. First, many drives were laid to a bare 2 to 3 inches over sand, so they crack at the first good settle. Second, the drive is often the only paved access to a detached workshop, guest suite, or rear addition, and resurfacing there means matching the new slab to the older one without creating a lip that catches a trailer wheel or a lawn mower deck. Contractors working 33143 also work under unincorporated Miami-Dade permitting rather than a city hall, and while a residential drive usually doesn’t require a permit, ANY re-grade, drainage change, or right-of-way crossing does. Our team has up to 12 years of experience with exactly this kind of lot, and the 730-Day Done Right Promise applies to every driveway we lay in Glenvar Heights.
Serving Glenvar Heights, FL – Our Local Coverage Area
We serve Glenvar Heights and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Asphalt Driveways & Resurfacing in Glenvar Heights

A typical residential asphalt driveway in Glenvar Heights takes 2 – 4 working days from demo to final compaction, plus 48 – 72 hours stay-off time before you drive on it. Larger acreage drives can push to 5 days. Call (888) 418-7102 for a site-specific schedule.
Most residential driveway replacements in Glenvar Heights don’t need a county permit, but any project that changes drainage, crosses a right-of-way, or touches a drainage easement at the US-1 or Palmetto edge usually does. We flag permit scope in the written estimate so there’s no week-three surprise.
The base is the biggest cost driver, and it’s the part that determines whether you get 15 years or 5. Asphalt itself is a fixed per-square-foot material. The base is where a $3,500 job and a $9,000 job in Glenvar Heights differ. Call (888) 418-7102 and we’ll assess your existing base honestly before quoting.
An overlay works when the existing asphalt is sound, level, and only lightly worn, and it saves roughly 20 – 35% vs. full replacement. If the base is compromised or the surface is cracked through, oversized, and patched, demo and rebuild is the only honest answer. We’ll tell you which one your drive needs in writing.
Every asphalt driveway we install is covered by our 730-Day Done Right Promise. That’s workmanship coverage for two years, on top of the standard material expectations for hot-mix asphalt, and it’s what keeps the estimate worth comparing against a handshake quote. Call (888) 418-7102 to talk through the details.
Get a free on-site estimate for asphalt driveways & resurfacing in Glenvar Heights
We’ll come out, measure the actual slab, probe the base, and hand you a written line-item estimate before you commit to anything. Live person on the phone, 24/7, at (888) 418-7102. Upfront pricing, no surprises, and the same 730-Day Done Right Promise that backs every job we take on. If you’re pairing a new drive with other exterior work, homeowners often combine it with Chain Link Fence in Glenvar Heights or ADU Site Prep & Utilities in Glenvar Heights so access and layout get planned once. You can also see the whole exterior scope on our Driveway & Pavers service page, or check the full Glenvar Heights service area to see what else we handle here. Call (888) 418-7102 to schedule.
Written by the team at Groundwork Construction Co.












