







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Glenvar Heights, FL: What It Costs and How Long It Takes
Concrete driveways & concrete work in Glenvar Heights, FL run $4,500 – $12,000 for a full driveway pour, and a straightforward 400 – 600 sq ft slab is typically a 3 – 5 day job from demo to first drive-on. Most of the driveways we pour here replace tired 1960s slabs, cracked aprons, or gravel pull-offs on the 33143 ranch lots that fill this pocket of Kendall. Call (888) 418-7102 for a free on-site estimate with a line-item quote in writing. The number you see is the number you pay.
Key takeaways
- Full driveway pour: $4,500 – $12,000. Replacement with demo and haul-off: $5,000 – $14,000.
- Most jobs are 3 – 5 working days, weather permitting. The wet season (May – November) can push curing and pour days.
- Concrete is the value play. Pavers cost more up front ($7,000 – $18,000) but are easier to repair in sections.
- Unincorporated Miami-Dade permitting applies, not a city hall. We pull it and pass inspection for you.
How we pour a driveway in Glenvar Heights, stage by stage

Concrete is a wet product that sets in hours and lasts decades, so the sequence matters more than the pour itself. Here is what actually happens on your property, and where you make the calls.
Day 1: site check, layout, and demo
We walk the existing slab or ground, confirm the widths and the driveway apron at the swale, and mark the layout in paint so you can see it before anything moves. Demo of an old slab or removal of gravel and root mass happens the same day. You decide the driveway width here (a single-car run is usually 10 – 12 ft; a double is closer to 20 ft) because it drives every number after this.
Day 2: excavation, base, and grading
We dig to depth, compact a compacted-limestone base, and grade so water runs to the street or a drain and not toward the house. This is where a lot of cheap jobs fail: skip the base and the slab cracks within a few seasons. You confirm the base depth (4 in is standard for a residential driveway, 6 in for anything a heavy truck will sit on) and we set the formwork.
Day 3: rebar, forms, and inspection
Rebar goes in on chairs, the forms are squared and set to the right slope, and we call the inspection if the scope triggers it. If your project is part of a full Driveway & Pavers in Glenvar Heights plan, we coordinate the pour with the rest of the hardscape so the heights and joints line up.
Day 3 or 4: pour and finish
A 4,000 psi mix gets poured, screeded, and finished. You choose the surface at this point (broom, exposed aggregate, or a stamped pattern) and whether you want control joints cut in a set pattern. Broom finish is the practical default for a Florida driveway; it grips when wet.
Day 4 – 5 and beyond: cure, seal, and walk-through
Concrete cures over 28 days to full strength, but you can usually drive on it after 7 days and park on it after about 10. We do a final walk-through, confirm the joints and edges, and hand over the paperwork. If you’re also replacing the garage-side entry, homeowners often pair this with Door Installation in Glenvar Heights so the threshold and new slab meet cleanly.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
- Standard broom-finish concrete ($4,500 – $12,000 installed): The most cost-effective driveway on the market. Holds up well to South Florida sun, needs resealing every few years, and cracks occasionally (which is normal). Best for a family car driveway.
- Exposed aggregate: Richer texture, hides tire marks, costs roughly 15 – 20% more than broom. Slightly harder to clean if oil leaks onto it.
- Stamped concrete: Mimics pavers or stone for a fraction of the price. Sits at the upper end of the concrete range. The trade-off: it chips, and color can fade faster in strong UV.
- 4,000 vs 3,500 psi mix: Go 4,000 psi for anything driven on regularly. It costs a little more per yard and lasts noticeably longer.
- Control joints: Cut joints every 8 – 10 ft, in a pattern. Skip them and you get random cracks instead of planned ones. We build this into every pour.
- Rebar vs mesh: Rebar (grid or mat) is the stronger reinforcement. Mesh is cheaper and fine for light foot-traffic slabs, but a driveway with vehicle weight wants rebar.
- Apron and swale details: The transition at the street and at the garage. Unincorporated Miami-Dade has opinions about how a driveway meets the swale, and we build to spec.
For the wider hardscape picture, our Driveway & Pavers service covers the pavers, sealing, and patio side of the property.
What Concrete Driveways & Concrete Work costs in Glenvar Heights, FL

The real range is $4,500 – $12,000 for a new concrete driveway pour, and $5,000 – $14,000 when you’re replacing an existing one and hauling off the old slab. That spread is honest, not a sales hook. Here is what pushes a job to one end or the other.
- Size: A 400 sq ft single-car apron sits near the bottom. A 900 sq ft double with a turnaround sits near the top.
- Existing condition: Removing a thick old slab, tree roots, or a failed base adds cost. A clean dirt pad is cheaper.
- Base and grading: More excavation or slope correction to move water away from the house costs more.
- Finish and mix: Broom is the baseline. Stamped or exposed aggregate adds 15 – 30%. 4,000 psi mix adds a little per yard.
- Permit scope: A simple driveway pour rarely triggers a full plan review, but an apron change or drainage tie-in can. We handle the paperwork either way.
Your written estimate lists the square footage, base depth, reinforcement, mix strength, finish, and disposal. What it typically does not include: new sod or landscaping repair beyond basic rough grading, drainage you add later, and any concrete that’s part of a wall footing or structural tie-in.
See the difference
Before
After
Before
After
Before
AfterWhat Glenvar Heights homes specifically do to this job
Glenvar Heights is a small, largely built-out unincorporated pocket of Kendall, squeezed between US-1 and the Palmetto Expressway, and almost every job here is a renovation or rebuild rather than a new subdivision pour. That changes the driveway work. The 33143 housing stock is dominated by 1950s – 1970s concrete-block ranch homes on generous lots, and many of them are mid-renovation or being popped up. When a homeowner adds a second story or an in-law suite, we often find undersized footings and rusted rebar where the old slab meets the additions. Tying a new driveway pour into a house that’s changing shape is where our experience shows. And because this is unincorporated Miami-Dade, permits go through the county, not a city hall. Post-1994 High-Velocity Hurricane Zone code also applies: product approvals and drainage details get more attention than they do in a neighboring city. Permit delays and our May – November storm season both shape the schedule, so we build the pour days around the forecast. Homeowners planning more than a driveway often pair this with ADU Site Prep & Utilities in Glenvar Heights to get the slab and utility routes right the first time. We cover all of Glenvar Heights, including the streets just off US-1 and the quiet interior blocks.
Serving Glenvar Heights, FL – Our Local Coverage Area
We serve Glenvar Heights and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Concrete Driveways & Concrete Work in Glenvar Heights

Most driveways are a 3 – 5 working day job from demolition to final walk-through, plus about 7 days before you drive on it. A large double driveway or one that needs extra grading can push toward a week. Storm season can add a day or two for weather. Call (888) 418-7102 for a schedule built around your property.
A straight driveway replacement usually does not require a full plan review, but apron changes, drainage tie-ins, and structural work do go through unincorporated Miami-Dade. We confirm the requirement for your specific scope and pull the permit if one is needed. Call (888) 418-7102 to have us check your address.
Yes, in most cases. A driveway pour is a surface and subgrade job, not a foundation job. If an underground line or a structural footing runs under the driveway, we flag it before demo and plan around it rather than through it. That’s a conversation we have at the site visit, not after the concrete is wet.
A new concrete driveway is $4,500 – $12,000, and replacement with demo and haul-off is $5,000 – $14,000. Smaller aprons come in lower. Call (888) 418-7102 for an exact quote; estimates are free and written line by line.
Every project is covered by our 730-Day Done Right Promise. If something isn’t right, we make it right. Concrete is a natural product and hairline cracks can appear as it cures, but a well-built pour with proper base and joints stays solid. We back the workmanship in writing.
Get a free estimate for Concrete Driveways & Concrete Work in Glenvar Heights
Call (888) 418-7102 to schedule your free on-site estimate. We’ll walk the property, measure the layout, confirm the base and drainage, and hand you a written line-item quote. A live person answers, day or night. Our technicians have up to 12 years of experience, arrive in uniform, and background-checked. Planning a bigger project? We handle it from foundation to finish line.
Written by the team at Groundwork Construction Co.












